Your Cart

eSun eSmooth 1.75mm 0.5kg Roll - Natural, filament- Lumin's Workshop

eSun eSmooth 1.75mm 0.5kg Roll - Natural

eSun eSmooth 1.75mm 0.5kg Roll - Natural



0.5kg of eSUN eSmooth 3D printing filament comes vacuum sealed inside a cardboard box.

  • Can be polished by using isopropyl alcohol
  • Translucent, white appearance
  • Non-toxic, tough, hard to break, good temperature resistance and creep resistance
  • Good print precision, no warping, stripping or stringing
  • Environmentally friendly, stable performance, more refined and brighter after polishing, complete decomposition, no carbonation and no residue in 600 ℃, can be used for metal casting.

Print Settings

  • Best print temperature: 190-210℃
  • Bed temperature: 45-55℃
  • Feed rate: 30-90mm/s
  • Idling speed: 90-150mm/s

Please note: eSmooth absorbs moisture easily, so it is recommend to dry before printing. Remember to choose an ethanol solution over 99.7% purity and work with a spray type polisher for polishing.

When polishing:

  • Hang the prints in the air to make full contact with ethanol vapour. The whole process takes 20-30 minutes.

After polishing:

  • The prints normally turn white and soft. Just use tweezers or other tools for air drying. Do not touch by bare hands.
  • To achieve the best polishing effect, 3-5 days air drying will volatilise solvent on the surface and form a hardened layer. Do not dry with oven, or the solvent will volatilise and destroy the polishing effect.